Bathroom Sink Not Draining? Here’s How to Fix It

A bathroom sink not draining does not always mean that it is time to call and hire a plumber. This DIY guide to unclogging a bathroom sink is all you need. Yes, before you plan on calling the plumber near Lancaster, CA to unclog your bathroom sink, put down your phone and read this article until the end. 

How To Unclog A Bathroom Sink

Unclogging a bathroom sink is a try-and-test job. All the methods that will be listed below can be done at home. If one thing does not put an end to it, you can try the other one until your bathroom sink starts to drain smoothly. However, if everything else fails, and you see that the bathroom sink not draining issue is still there, give the plumbing experts at Arctic Air & Plumbing a call.  

#1: Hot Water

While you are waiting for the water to boil, you need to remove as much of the standing water from the sink. It is a good choice to wear rubber gloves. When the water is heated, just pour the entire kettle into the sink and wait.

Make sure to give the hot water time to work its magic. Repeat this several times if the clog has not budged. Trust us, this technique often gets the sink unclogged.

#2: Salt & Hot Water

Just like you, your bathroom sink may also enjoy a nice exfoliation. Keep in mind that hot water helps loosen up the debris and grease, but the salt scours the insides of the pipes. It helps in removing more material than hot water alone.

You need to pour a full cup of table salt into the sink and then pour boiling water over it. Let it sit for a few minutes and then flush it with more hot water.

#3: Vinegar & Baking Soda

Now we’re talking about your favorite science experiment. Yes, it actually works. We know that vinegar and baking soda create bubbles when combined.

The combination of vinegar and baking soda poured into the drain will help loosen the sticky debris from the drain. Wait for 15 minutes and then rinse the sink with hot water to see if the clog has cleared.

#4: Baking Soda & Salt

If you want a scrubbing powered solution, then try mixing baking soda and salt with hot water.

Mix half a cup of salt with a full cup of baking soda and pour the mixture down the drain. Let the mixture sit in the drain for a couple of hours before flushing it with hot water. Repeat the process if needed.

5: Plunger

If the above-mentioned tips and tricks didn’t work, then it is time for you to bring in the plunger. It doesn’t matter if you have a double bathroom sink; just seal the first side with a wet cloth or a stopper.

Since the plunger requires a tight seal, you will need to fill the sink with enough water to submerge the bell of the plunger. Only stop plunging until you hear the suction clear the clog. Don’t forget to wash your hands afterwards.

#6: P-Trap

When you plan to unclog a sink drain with a plunger, and it doesn’t work. There could be a high chance that there is debris buildup in the P-trap beneath the sink. Just before you plan on opening the p-trap, place a bucket underneath it. Some gunk will fall out, but you can handle it. Once the drainpipe is cleared, replace the P-trap and let water run through it again.  

#7: Coat Hanger

A good quality coat hanger might be the most underrated tool when it comes to clearing a clogged drain. The coat hanger might not be able to reach as far as a plumber’s snake, but it will still get the job done.

Conclusion

If you are not comfortable with unclogging your bathroom sink or your drain, you always have the choice to call and hire an expert from Arctic Air & Plumbing. We have a team of highly skilled plumbers who have years of experience. Trust us, we will get the job done right the first time.